Latest Articles added to -www.wermac.org-
February 5, 2015
what is the best connection? pipe nipple 1/2 (ANSI) to 1/2 tubing?
January 1, 2015
Introduction to Air Cooled Heat Exchangers (AC-HEs)
December 28, 2014
Foreword - Piping Specifications
Do not rely on "what was installed before must be right"
November 1, 2014
Generic Marking Standards and Requirements for Steel Pipes, Steel Flanges, Butt Weld Fittings, Valves, Fasteners
November 1, 2014
Why its always advised that reducer must be closer to the control valve?
November 1, 2014
Why 10" schedule 80 CS pipe has higher wall thickness, than 10" schedule 80s SS pipe?
June 27, 2014
Dimensions of Ring-Joint Facings - ASME B16.5 - All Pressure Rating Flange Classes
June 14, 2014
Do you have any recommendations for coatings to put on spectacle blinds?
June 4, 2014
What about Bolt Hole Orientation for flanges NS 2539 and etc.?

Archive

Werner Sölken 2008 - 2015. All rights reserved.  www.wermac.org uses Google Analytics